Error sending command

Rush68 · Post by **Rush68** » Thu Oct 17, 2019 3:46 am

This happens to me when I send to print.
after three or four attempts already prints, I upload video, sorry, How can I upload a video?

Post by **William** » Thu Oct 17, 2019 9:25 am

Hi. you can provide the link address of your uploaded video.
So that we can solve the problem better.

Rush68 · Post by **Rush68** » Thu Oct 24, 2019 6:33 am

https://we.tl/t-iv9KfXsJHu
here is the link for the video,
this happens when i sent to print,
after several attempts print

Post by **William** » Thu Oct 24, 2019 9:13 am

Hi,You can check the status of the limit switch,
connect to the printer via usb and enter M119 in the manual control of the Repetier Host.
You can refer to this: http://www.geeetech.com/forum/viewtopic ... 13&t=17042

Rush68 · Post by **Rush68** » Fri Oct 25, 2019 3:01 am

In my case, everything is fine, I send home and everything is fine.
The same with the scripts.
the problem is that I send to print and everything is fine sometimes, but I often send to print and instead of going down after doing at home, it goes up

Sorry my english is very bad

Rush68 · Post by **Rush68** » Sun Oct 27, 2019 4:48 am

When send to print and instead of going home and then lowering goes to the coordinate in z 204.71, thats is the crash.

Rush68 · Post by **Rush68** » Fri Nov 08, 2019 12:43 pm

I solved the problem.
If I send to print from the sd card everything goes very well
thanks for your support

Geeetech

Error sending command

Error sending command

Re: Error sending command

Re: Error sending command

Re: Error sending command

Re: Error sending command

Re: Error sending command

Re: Error sending command