A10 doesn't start

Federico · Post by **Federico** » Tue Jul 23, 2019 11:30 am

Hi,
My Geeetech A10 was working ok. I stopped a print job and turned the printer off.
Later, when I turned it on it does´t start, and the display shows two lines of black blocks, as can seen on the enclosed image.

Any hint on how can I make it come back to life?
Any help will be much apreciated!

Thanks!

Post by **William** » Tue Jul 23, 2019 1:52 pm

Hi, You can try 1. Reconnect the screen cable and see if the screen cable is broken.
2. If the screen is still not working properly after reconnecting, you can try to refresh the firmware.
I hope this can help you.

Federico · Post by **Federico** » Tue Jul 23, 2019 8:58 pm

Hi William,
Thanks for your answer.
I think the screen cable is ok.
How should I proceed to refresh the firmware?

Thanks and regards.
Federico.-

Post by **William** » Wed Jul 24, 2019 9:16 am

Hi, You can reconnect the screen line first. Poor contact may cause this to happen.
You can use this link: https://www.geeetech.com/download.html?download_id=30
to download the corresponding toolkits and files you need on the official website to refresh the firmware.

Federico · Post by **Federico** » Fri Nov 01, 2019 8:39 pm

I refreshed the firmware and everything went back to normal.

Post by **William** » Mon Nov 04, 2019 9:09 am

That's sound good.

Geeetech

A10 doesn't start

A10 doesn't start

Re: A10 doesn't start

Re: A10 doesn't start

Re: A10 doesn't start

Re: A10 doesn't start

Re: A10 doesn't start