Hi all out there - I would like to convert mu A10m to a Chimera extruder - I already have one here. The challenge is - how to get the electrical stuff working - two hotends..
Secondly - do I need to change the firmware?
Any tip welcome
Install a Chimera extruder on A10m
Re: Install a Chimera extruder on A10m
Hi, If you want to replace the hot end, you may need to replace the corresponding motor and wiring.
Change to the firmware corresponding to it.
Change to the firmware corresponding to it.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!