Just loving my new geeetech

[Leozumi]

Hey everyone,
I've printed calibration cubes galore, a few Pokemon figurines for my kids, and even a collet wrench for my CNC. I decided to try the standard benchy to help dial in my settings. I used Slic3rPE as the slicer with a recommended profile for my machine and started with the stock settings (225c hotend, 60c bed) and I'm using Amazonbasic's red PLA. Most everything came out well but there was plenty of stringing and sagging while bridging the windows. I then printed several at gradually lower temperatures (first layer always at 225, the rest at 220, 210, 200, 190) while leaving most of the other settings stock except speed and enabling retractions. I did end up slowing everything way down, especially the first layer, small perimeters, and bridging. I all but eliminated the stringing but the sagging over the windows has continued with little change through out the whole process.

[William]

Hi, you can try adding support or increasing the cooling rate of the fan.