A10 filament feeder motor not feeding
Re: A10 filament feeder motor not feeding
When you leave the filament out of the extruder and just heat the hotend up (make sure you leave a peace of filament in the runout sensor) and then move axis extruder forward.does it then run normally?
Re: A10 filament feeder motor not feeding
Possible contact oxidation. Sea shipping is corrosive. Train shipping on Silky Road loose screws...
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
Re: A10 filament feeder motor not feeding
Hi, you can check if your extruder motor is working properly for a week.
If not, you can try to swap the motor wires of the other axes to the extruder motor line for viewing.
Determine if the motor line is broken and this happens.
If not, you can try to swap the motor wires of the other axes to the extruder motor line for viewing.
Determine if the motor line is broken and this happens.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!