Z axis motors moving in opposite direction to each other!!!

[Anurakclark]

Hi guys,

Just in the process of setting up the printer, ive got to the stage the test the homing positions and have encountered a problem.

Ive tried searching, but having seen any posts on my issue.

When using Repetier, connecting to the printer and commencing the manual home, the x and y axis work fine. They hit the end stop and the test progresses to the next motor test. The last stage, the z axis motors turn in the opposite direction to each other. Left side is .reverse phone lookupnba reddit pcpartpicker



When adjusting the firmware (True/false) this just switches the issue, left side goes down and right side goes up.

Is this just a simple wiring issue? have I plugged into the wrong point on the board? The board is GT2560

Thanks in advance for any help and advice anyone can offer

[GAQ]

Hi,
I've heard of this problem before...
One builder had a circuit board with an incorrectly mounted socket...
It can be solved.
This post thread may help you...
https://www.geeetech.com/forum/viewtopi ... 996#p98996
Gerry

[William]

Hi,You can check if your wiring is correct.
you can refer to this:

A+接线板.jpg (598.18 KiB) Viewed 4621 times