I am beyond confused by this. If someone could help me it would make my day.
Filament "Swirling" when coming from the extruder???
-
Salty Stump
- Posts: 2
- Joined: Mon Oct 07, 2019 2:23 am
Filament "Swirling" when coming from the extruder???
Everything on the printer is in the right place, but when i tested it out the filament started spiraling as it came out...
I am beyond confused by this. If someone could help me it would make my day.
I am beyond confused by this. If someone could help me it would make my day.
Re: Filament "Swirling" when coming from the extruder???
Post photo.
- coriolis force plus wind
- overheated carbonized plastic piece in hotend
- bad shape of output nozzle (probably after crash to bed)
- coriolis force plus wind
- overheated carbonized plastic piece in hotend
- bad shape of output nozzle (probably after crash to bed)
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
Re: Filament "Swirling" when coming from the extruder???
Hi, Can you provide a specific picture?
So that we can solve the problem better.
So that we can solve the problem better.
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!