Probably bed is not flat. Get my A10 profile and when it does circle about object, you can fine.tune bed level.
From front side view of bed knobs:
turn ===> to make bed low
turn <==== to make bed high
One whole turn is 0.5mm.
A10 Freakout
Re: A10 Freakout
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
Re: A10 Freakout
You can also check Y axis wheels, if you can move your bed left and right or up and down, they need to be adjusted. If they loose bed leveling will be compromised.
Re: A10 Freakout
Hi,For nozzle clogging cleaning you can refer to this: http://www.geeetech.com/forum/viewtopic ... 98&t=68671
Regarding the hot bed problem you can remove it to see if it is level.
Regarding the hot bed problem you can remove it to see if it is level.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!