3d touch with Prusa I3 W

[William]

About the GT2560 board you can refer to this:https://www.geeetech.com/download.html?download_id=43

[Katsuki]

So I have it responding to test codes, when powered on the unit self tests twice, I set auto home and it does the X/Y then centers the table and starts to move down.

I simulate hitting the table with my finger but the z axis doesn't stop. I don't want it to crash into my bed and break. why does it not stop?

[William]

Hi, Are you calibrating 3d touch?
If there is still a problem, it is best to provide a specific video.
So that we can solve the problem better.

[Katsuki]

When I do calibration and I enter G28 the X/Y homes okay and the Z axis comes down and doesn't stop, I have to kill power to prevent damage

[Katsuki]

I have uploaded a video hopeful to help.

https://photos.app.goo.gl/Dn1EVJoQn1yjp4ri7

[William]

Hi, you can check if the z min line is connected,
or you can do a test.
Is the upper limit z switch valid?
Perhaps the pin of z min is broken,
so it can not receive the endpoint information.

[Katsuki]

I think this too and I have asked my seller for new unit. Hopefully this is problem.

Should the end stop status report be updated for z axis by the 3dtpuch pin?

[William]

Hi, If you have a problem with 3d touch,
you can contact your sales to replace it.

I hope this can help you.

[Cipper]

Hi, i'm having your exact same problem, is it possible to know how you solved it?
was it defective?
thank you so much