A30 Bed level operation in Cura via USB/SD

[CallXYZ]

When printing a file directly from the SD card with the A30 with Sensor, the printer is performing a checkup/leveling of the bed before printing.
It checkes 10 points on the bed.

When printing with Cura over the USB cable, the printer is performing only a short test and is touching only the middle of the bed.

Judging from the print quality, the detailed checkup/leveling with 10 measuring points is needed to ensure good quality

My guess is that Cura needs instructions for the detailed checkup/leveling in the start gcode.
Can we get the correct instructions for the start gcode?

[William]

Hi, You can level the points of the hot bed before printing starts.