managed to use an old cura 15.4.6
on lcd screen on a10 X is flashing x then ? then X then ? same with y and z
a couple of questions
Re: a couple of questions
Last edited by ebam2014 on Tue Aug 27, 2019 8:53 pm, edited 1 time in total.
Re: a couple of questions
Hi, If you use CURA slicing software, you can update the HEX format firmware;
If you use Arduino you can update the firmware in CONFIGURATION_H format.
But what is Cuda?
If you use Arduino you can update the firmware in CONFIGURATION_H format.
But what is Cuda?
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!