Everything seems to be working more or less perfectly now, but my extruder stops working about 20 mins into any print. Is this a common problem? How do I fix it?
This was PLA at 200 degrees, which seems to work for a while.
Prints stopping halfway through!!
Re: Prints stopping halfway through!!
Hi, You can check if the thermistor wiring of your hot end is fully connected.
Are you printing via sd card?
Or use USB to connect to the printer and slice software for printing?
Printing via sd card maybe your motherboard problem;
Printing via a USB connection may be caused by hitting the USB line midway.
I hope this can help you.
Are you printing via sd card?
Or use USB to connect to the printer and slice software for printing?
Printing via sd card maybe your motherboard problem;
Printing via a USB connection may be caused by hitting the USB line midway.
I hope this can help you.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!