underextrusion problems on A10M

[0xc6]

Hello,
So I recently bought an A10M, but i can't seem to get the extrusion working quite right.
Whenever I print something the lines don't seem to connect whatever I do.
I have tried:
Checking if PTFE tube is all they way down
Increasing nozzle temperature
Setting ESteps higher
Checking extruder tension
Adjusting slicer settings


Is there anyone who could help me, or give me advice on this matter?
Thanks!

[0xc6]

Hi, thanks for your reply!
I tried that, it did not make any diffrence.
Even tried going to 500, that did not improve things either and I still had the same issue.

[0xc6]

Hi!
I checked that, I am getting 100mm even a bit more.

[playfutbol2]

What size drill bit / what diameter did you drill it out to?