Hello everyone,
I'm totally inexperienced with 3D printers and I'm having issues with my G2s.
I've assembled it and triple-checked the wiring, but when I power it up, I get the reading you can see in the attached picture. From what I understand, it means that the board receives no thermistor readings. All thermistors except the heat bed's one are connected (it was faulty and I am waiting for the replacement part to arrive).
Any idea of the cause, or how I could tackle the problem?
If the exact same issue has been solved in another thread, just redirect me to it.
Thank you
G2s error - no thermistor reading
G2s error - no thermistor reading
- Attachments
-
- IMG_20190810_161138.jpg (160.66 KiB) Viewed 11676 times
Re: G2s error - no thermistor reading
Hi, When you unplug the hotbed and printhead from the motherboard, what is the display on the screen?
If you still see the picture you provided, maybe you need to check your hotbed and print head.
If you still see the picture you provided, maybe you need to check your hotbed and print head.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: G2s error - no thermistor reading
Yes, disconnecting all or some of the printhead and hotbed connections has no effect on the readings.
Could all of the thermistors be faulty?
Could all of the thermistors be faulty?
Re: G2s error - no thermistor reading
Hi, If your printer is Delta G2/G2S series,
before checking this please install the firmware for I3X or I3 pro-C,
cause when you short out the thermistors with the firmware of G2/G2S,
it will always show 0 degrees on the LCD, though it is exactly MAX temp error.
and you can also refer to this :http://www.geeetech.com/forum/viewtopic ... 23&t=17030
before checking this please install the firmware for I3X or I3 pro-C,
cause when you short out the thermistors with the firmware of G2/G2S,
it will always show 0 degrees on the LCD, though it is exactly MAX temp error.
and you can also refer to this :http://www.geeetech.com/forum/viewtopic ... 23&t=17030
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!