New Bed, I would like to know if it is any good

[3dPrinterNoob]

Hello,

I am looking to buy a A10M but I was very disappointed with the change to ship with a new bed (plastic) instead of the glass one.

Can you please share pictures and specs of the new bed, is this for cost savings only or is it better in any way? I really like glass beds so this does looks like a cost saving measure.

Any pictures of the new bed ?

[William]

Hi, The A10M glass plate changed to Mylar piece.

[3dPrinterNoob]

Yes,

Can you post pictures of it?

Why changing it?

[William]

Hi, It can make the model more stable and then will not cause damage during transportation.

麦拉片.jpg (368.55 KiB) Viewed 3840 times

[pierredesa]

Bought the A10 with the new mylar bed. Prints stick very well to the bed... however printed pieces are often very hard to remove also. I did not try the super plate so I can't compare but from the reviews I saw it seems easier to remove prints from bed once cooled with the super plate.