E180 LCD has stopped working

[AleB737]

Hello, today after finishing a print, on the LCD, a message appeared that said: "incorrect calibration" (or something like that, now I can't remember perfectly), and there was a button with an "Ok" to press . I tried to press it two or three times, and at a certain point, the printer restarted. Now the LCD is on and shows the main screen, but does not respond to any touch. I tried turning the printer on and off, but nothing changed. The firmware is updated to the latest version. Do you know what I could do?

[William]

Hi，you can check if the screws on the screen link are loose.

[AleB737]

Hi, the screws seem narrow to me. Isn't there a way to start the screen calibration via the PC?

[William]

What is the screen calibration you are referring to? I mean maybe the screen screw is too tight and the screen is not responding.

[AleB737]

Now I tried to slightly loosen the screws, but nothing changed. What I mean is if there is a way to reset it via the PC

[William]

You can refer to this:http://www.geeetech.com/forum/viewtopic ... 64&t=60677

[AleB737]

I tried to do everything the topic says, even doing everything that is done in the video, but it doesn't work. The screen turns on but does not respond to touches

[William]

Hi, You can contact your sales to change the screen.

[William]

Hi, You can contact your sales to change the screen.

Hi, the screws seem narrow to me. Isn't there a way to start the screen calibration via the PC?

Hi, very good idea, but it seems impossible.

You can contact your sales to make a screen change.

[Feltner1]

I have exactly the same problem. Anyone got a suggestion?