A30 Finish Print Beep and Home

[sdbowen999]

I looked through the forum but didn't have any luck with my search.

Anyone know how to turn off the beep and home at the end of a print? I have my end gcode set to home the X axis and move the Y axis so the bed is forward. But after that, the A30 firmware still homes the bed and beeps when it is complete.

I want to turn off the beep and not home the bed. Basically, I want the end gcode to be the end of the program.

[William]

Could you tell us your fw version?
You can try to upgrade it to latest version fw.

[sdbowen999]

Firmware 1.37.58
Hardware version 3.2

[William]

The beep is reminding you of the print finish.
The Home:
Z-axis raise ;
X axis and Y axis auto home
You can feedback it to :
technical@geeetech.com

[sdbowen999]

Yes, I know what the beep does. I don't need the printer to let me know it is done. Also, homing the bed makes the finished print unreachable.

Is there a way to turn off the beep and the home?

[Sergio46]

Same problem here, any solutions yet?

[Napsterium]

Try changing the G-CODE settings in your slider program. In CURE look in SEETING>MACHINE SETTINGS/PRINTER - change END G-CODE and remove "G28"-line as this is the home setting