Videos of MK8 Extruder assembly

[zhangxueyou]

In this video, you will see how to tear the mk8 extruder down, and how to replace new extruder kits.
https://www.youtube.com/watch?v=aPvVUZQnOMM
How to replace extruder thermistor:
https://www.youtube.com/watch?v=FR0n2FHrjmc
How to replace nozzle:
https://www.youtube.com/watch?v=t2tUxrZDi8o
How to level dual extruder:
https://www.youtube.com/watch?v=XGpcueI ... e=youtu.be

[mava70]

hello the heater and the thermistor move inside the hole out and in, can be fixed someway?

[Mark]

there's a setscrew for the heating cartridge, did you see that? and you can use a cable tie to tie them up.

[mava70]

Hello there is a small hex screw next to the hole in the back but I tryed to turn clockwise the screw go inside the hole a lot but don't fix. Should I turn a lot more?

[Mark]

I remember the setscrew is side of the heating block not in the back, maybe you need to remove the sponge thing to check it, and you can screw it a little tight.

[calabrovarijo]

In this video, you will see how to tear the mk8 extruder down, Audacity Find My iPhone Origin and how to replace new extruder kits.
https://www.youtube.com/watch?v=aPvVUZQnOMM
How to replace extruder thermistor:
https://www.youtube.com/watch?v=FR0n2FHrjmc
How to replace nozzle:
https://www.youtube.com/watch?v=t2tUxrZDi8o
How to level dual extruder:
https://www.youtube.com/watch?v=XGpcueI ... e=youtu.be

is side of the heating block not in the back, maybe you need to remove the sponge thing to check it, and you can screw it a little tight.

[randyhavens]

You can try removing the sponge thing to check it, and screw it a little tight.
gmail sign up