geetech a10t
Posted: Mon May 30, 2022 3:08 pm
so I have a geeetech a10 t same as the a10 just more colours
I just put a BL touch on it and im getting it ready to print.
BUT two issues one the z axis stop switch is always lighted now but doesn't seem to work
and two once i set it to auto home it does zx and y axis fine but once it goes to z it hits the heated bed and begins to grind.
Any ideas how whats going on ..thanks..
I just put a BL touch on it and im getting it ready to print.
BUT two issues one the z axis stop switch is always lighted now but doesn't seem to work
and two once i set it to auto home it does zx and y axis fine but once it goes to z it hits the heated bed and begins to grind.
Any ideas how whats going on ..thanks..