Geeetech

Hello everyone,

I am printing with a twin extruder single nozzle A10M and using Cura as slicing software. The item I am trying to print is white with a small amount of black at the top.

When printing the nozzle moves to start the tower and purges out black (only the black extruder is turning), it then starts to print the product in white which causes it to turn from black through grew scales to white. Once it has produced the first layer it returns to the purge tower and repeats this process. It looks good as a Zebra print, but how do I make it so that it will only purge out white until it gets to the bits I want black?

P.S. If I print two of the same product the second is produced with the correct colours in the correct order meaning the first is effectively a purge.

Can any one offer any assistance or had this problem before? I am not nomegle xender
ew to printing but I am new to twin extruder printing.

Thank you in advance for any and all help.

I thought I was the only one with this problem. Rummaged through the entire Internet: various services, forums, and so on. in search of an answer. But it didn't come to anything. Several times I saw on the forums people complaining about similar problems but with other models. As far as I understand, this is somehow related to the color perception of the device, but this is not accurate.

Thus, this post of Purge tower incorrect filament, which is so creative and relevant for all, but there are also very beneficial and authentic services available like to have the most interesting guest post backlinks, which are so relevant and authorized to having from them in all over the USA.