Geeetech

Hi,

I have a problem with my A10 with a 2560 V4.0 board. I cannot find any firmware with 3D Touch support only for V3.x or for V4.1
I've tried these but it didn't work.
And I've tested with the A10T that support the V4.0 board, but it doesn't work, the 3D touch only makes the self-test pin in pin out, when I start the printer, it turns on the red LED and that's it.

Please can some one tell me which Firmware is the right for my Printer and Board are.

Same Day, Same problem with my A10 with a 2560 V4.0 board and 3d touch. There doesn't seem to be firmware support for V4.0 Does anyone have a solution to this issue?

And there is a solution. On the Geeetech download page he file A10_G05_v11.8.2 3dtouch.hex. This works perfectly on my A10 however now my machine info states I have a version 3 board.