Geeetech

Hello everyone,,,
I bought this printer last year and now i figured out that the prints are "out of square". I don't know how to explain the issue properly but when the printer draw in the Y-axis it doesn't make the line in the required angle. Also, the slicer doesn't match the center of the bed with the printer. I use Repetier but i tried with Slic3r and Ultimaker Cura with the same issues.
The only modification that I made in the printer was low 1mm the Z endstop because I couldn't calibrate the bed properly.
anyone know what problem can make this issue?
https://showbox.bio/ https://tutuapp.uno/
Regards!!

Panda Express has a tremendous client base. It is famous for its pandaexpress/feedback amicable staffs, new and scrumptious Chinese food. In any case, at whatever point you run over a disillusioning survey about Panda Express, they answer to the individual, saying 'sorry' and trusting a similar mix-up won't occur once more.