GeeeTech A10 v4 Board 3D Touch Questions?
Posted: Tue Sep 21, 2021 4:04 pm
Hello everyone,
I have a GeeeTech A10 with the V4 2560 board. It's a full width electronics setup, unlike the older versions. This model also comes with a metal L bracket for the 3D Touch. The issue is there is NO information anywhere about the offsets of this bracket, nor are there any firmware available for the V4 board and 3D touch pre-compiled.omegle xender
I did make this work already with the latest 2.0 marlin; but I was curious if my measurements are correct for the probe offset. Anyone else got this board and measured it? -47, -9 is what I measured.
I have a GeeeTech A10 with the V4 2560 board. It's a full width electronics setup, unlike the older versions. This model also comes with a metal L bracket for the 3D Touch. The issue is there is NO information anywhere about the offsets of this bracket, nor are there any firmware available for the V4 board and 3D touch pre-compiled.omegle xender
I did make this work already with the latest 2.0 marlin; but I was curious if my measurements are correct for the probe offset. Anyone else got this board and measured it? -47, -9 is what I measured.