A10M - bed and E1 temp suddenly stopped reporting

[GabrialMish]

I moved the printer and now the bed shows 112c when idle (and does not change when I unplug it from the main board) and and the thermister for E1 (wired into extra pins) now also shows -14c. The thermisters on both the bed and E1 are both ok and were working before I moved the printer. I have checked the connections with a multimeter and I am getting correct resistance values on both thermisters, but the board is not reading them

Since I havn't changed firmware or done anything at all in software, i'm thinking the board itself is faulty. Is there anything in common with the bed and pins (i'm having trouble finding the schematic I originally used. It's the 2 rightmost pins on the connector that normally only has a few wires on it, I had to add extra pins to it)https://speedtest.vet/ https://vidmate.bid/
Top