Need to know Z steps!
Posted: Thu Jul 29, 2021 6:14 am
I thought my z-axis motor died, and after some time diagnosing, I found that my E and Z steps/mm had both been zeroed.
I had recently done Estep calibration, so I remember what that value was, but I'm not sure of what the Z-steps/mm should be.
A10T
Other than Octoprint, its all stock.
What should the Z-steps/mm be???
TIA
I had recently done Estep calibration, so I remember what that value was, but I'm not sure of what the Z-steps/mm should be.
A10T
Other than Octoprint, its all stock.
What should the Z-steps/mm be???
TIA