A10T - 3d touch autolevelling - good or not?
Posted: Fri Jun 11, 2021 5:42 am
hi.
i have no experience in 3d printing.
with my new A10T comes a 3d-touch-autolevelling-kit.
so my question:
is the instruction Sensor actually or old manual?
what are now the steps to make?
- new printersoft? https://snaptube.cam/https://9apps.cam/
- marlin how to change?
- can i go back if not working properly?
for me it seems not easy to install this sensor.
what is your suggestion?
i have no experience in 3d printing.
with my new A10T comes a 3d-touch-autolevelling-kit.
so my question:
is the instruction Sensor actually or old manual?
what are now the steps to make?
- new printersoft? https://snaptube.cam/https://9apps.cam/
- marlin how to change?
- can i go back if not working properly?
for me it seems not easy to install this sensor.
what is your suggestion?