Page 1 of 1
A10T leaking PLA through heater element holes
Posted: Thu Jun 03, 2021 6:39 pm
by jmd5757
Hi all, I have recently been getting Blops of PLA on my prints and found the PLA leaking out of the heater element holes, this is not some thing have come across before, can any one advise.
Re: A10T leaking PLA through heater element holes
Posted: Mon Jun 07, 2021 6:21 am
by sneazzy95
Hey, I don't get it. Could you give more details about your issue please?
Mini Militia App Lock
Re: A10T leaking PLA through heater element holes
Posted: Mon Jun 07, 2021 4:12 pm
by Admin
Hello, did you mean that your hotend leaked? Please try to tighten the nozzle. It may be that the nozzle is loose.
If it is a defect on the heating block that cannot be repaired, please contact geeetech and they will replace you with new parts.