Geeetech

Hello,

After smoking the motherboard, I have no idea why, I swapped the motherboard and driver. Now I have even more problems

Now my A10 only travels halfway. no matter if X, Y or Z if I move it manually or level, it only moves halfway. I only had the 1.8 on it, now Merlin 2.0. Nothing has changed. The stepper motors keep cracking, nothing fits.
In addition, when I connect the 3D daughter, the motor starts smoking on the X-axis.

The board is the GT 2560 V3.0 Protocol 1.0

Auto Bed Leveling (3D-Toch) is also installed

Can someone tell me what to do?

I also read something that the drivers should be set to 1.0V, how does that work.

Thanks in advance



greeting



Mathias

Hello,

nobody who can help?

Best regards

Mathias

Hello, according to your description, there is a high probability that the firmware is a problem. It is recommended that you reinstall the firmware:
https://www.geeetech.com/download.html?download_id=30
A10_G04 (GT2560V3 + CH340)

Hello.

thanks for answering.

I've done that in the meantime. The stepper motors for X and Y rattle, the whole printer vibrates.

Best regards

Mathias