3DTouch not using Mesh in Print
Posted: Sun Mar 28, 2021 10:23 pm
Hey there,
i installed the 3DTouch Sensor and activated it in Marlin. Now if Probing with G29 and printing afterwards it ignores the values.
I tried with M500 to save the values and read it with M420 S1 but that also wont help.
I use a self compiled Marlin 1.1.x rebug version because i have the Geeetech TMC2208 Silent Steppers installed and there is no official Firmware for it here.
What can i do to use the data from the 3DTouch Leveling?
EDIT: Here is the Marlin config i wrote:
Configuration.h
https://pastebin.com/0RsLuQkk
Configuration_adv.h
https://pastebin.com/gv9xGuhV
Best Regards
i installed the 3DTouch Sensor and activated it in Marlin. Now if Probing with G29 and printing afterwards it ignores the values.
I tried with M500 to save the values and read it with M420 S1 but that also wont help.
I use a self compiled Marlin 1.1.x rebug version because i have the Geeetech TMC2208 Silent Steppers installed and there is no official Firmware for it here.
What can i do to use the data from the 3DTouch Leveling?
EDIT: Here is the Marlin config i wrote:
Configuration.h
https://pastebin.com/0RsLuQkk
Configuration_adv.h
https://pastebin.com/gv9xGuhV
Best Regards