Bed not moving
Posted: Fri Mar 12, 2021 4:31 pm
Hello,
I have been having A LOT of problems with my Geeetech A10 printer lately. I've been able to solve a few of them by changing the hot end several times. My newest problem is that when I go to print something or level the heat bed, the heat bed will not move all the way forward! And when it prints it would make a loud boom noise once in a while and the current layer of the part will be printed completely shifted 1 cm to the left! Then about 30 minutes later I would hear the noise again and the current layer of the part will be printed another 1 cm to the left! I checked the belt and it was intact and the belt tension was fine, the bed was already leveled, and the stepper motor still works (not burned out). I have no clue what's wrong! Could it be an issue with the mother board or an old version of the firmware? Text To Speech Future Of Voice Over
Please help me figure out this extermly frustrating problem.
Thanks in advance.
I have been having A LOT of problems with my Geeetech A10 printer lately. I've been able to solve a few of them by changing the hot end several times. My newest problem is that when I go to print something or level the heat bed, the heat bed will not move all the way forward! And when it prints it would make a loud boom noise once in a while and the current layer of the part will be printed completely shifted 1 cm to the left! Then about 30 minutes later I would hear the noise again and the current layer of the part will be printed another 1 cm to the left! I checked the belt and it was intact and the belt tension was fine, the bed was already leveled, and the stepper motor still works (not burned out). I have no clue what's wrong! Could it be an issue with the mother board or an old version of the firmware? Text To Speech Future Of Voice Over
Please help me figure out this extermly frustrating problem.
Thanks in advance.