A10M Whats my Best way to fix my under-extrusion??
Posted: Sun Jan 31, 2021 8:38 am
Good Morning ya'll
I'm struggeling for some days now but cant seem to fix this problem
My printer is not extracting enoug plastic bij printing file's
The Hot end is all clean becaus its a new one.
when i changing filament en and when he push the filament back in there the PLA come's out the hot end without a problem,
so it tells me it most be a setting right?
But when i start printing my file,
i notice the filament is not getting pushed in correct or the my settings are still wrong
but i cant seem to see where the problem come's from or how to fix it
The flow is 130% and printing speed is set on low.
*Sorry Dont mind my bad English and if you need more information please let me know
Here below my settings Hope you can help me.
-Lars
I'm struggeling for some days now but cant seem to fix this problem
My printer is not extracting enoug plastic bij printing file's
The Hot end is all clean becaus its a new one.
when i changing filament en and when he push the filament back in there the PLA come's out the hot end without a problem,
so it tells me it most be a setting right?
But when i start printing my file,
i notice the filament is not getting pushed in correct or the my settings are still wrong
but i cant seem to see where the problem come's from or how to fix it
The flow is 130% and printing speed is set on low.
*Sorry Dont mind my bad English and if you need more information please let me know
Here below my settings Hope you can help me.
-Lars