I have levelled and levelled. I have done it with things cold. I have done it while it was hot. For me to get ANYTHING to stick, I have to use the blue tape method and even then, still have to wipe down with alcohol. Now what I am beating around the bush is I can ONLY print to the front 1/3 of the plate. Anywhere else and the PLA does not sick. I am running 200 on the head and 70 on the bed. At one time, I could print straight to the glass GeeeTech bed. then I added the BLTouch and it wen to crap after that. I put it all to the side for about a year and just pulled it out a few days ago. I removed the touch and flashed back to the 1.1.8 firmware. So that is pretty much it stands. If it's small and fits the front 1/3s of the plate, I can do it
Any suggestions? I was thinking maybe the plate was warped or something. I have seen where people have replaced the glass plate with a mirror or piece of plate glass. Am I going to have trouble removing the plate? Damage the bed heater? Help!
Thanks
Fred
