Print won't stop if filament run out
Posted: Fri Dec 25, 2020 6:24 pm
Hi all,
I newly installed my filament run out sensor to my A10 and activated it in the menu.
Before that I flashed the official Marlin 1.1.8 from the GitHub repo with the line of
"//#define FILAMENT_RUNOUT_SENSOR" changed to
"#define FILAMENT_RUNOUT_SENSOR".
So now when the filament runs out, the printer display shows me the "ERR: No filament" message, but won't pause printing, which I actually expected.
What am I missing here??? Do I need to tweak more lines in the firmware? Or do I need to add Gcode?
I am using Octoprint btw.
Any help appreciated! I'm completely stuck here...
Regards
I newly installed my filament run out sensor to my A10 and activated it in the menu.
Before that I flashed the official Marlin 1.1.8 from the GitHub repo with the line of
"//#define FILAMENT_RUNOUT_SENSOR" changed to
"#define FILAMENT_RUNOUT_SENSOR".
So now when the filament runs out, the printer display shows me the "ERR: No filament" message, but won't pause printing, which I actually expected.
What am I missing here??? Do I need to tweak more lines in the firmware? Or do I need to add Gcode?
I am using Octoprint btw.
Any help appreciated! I'm completely stuck here...
Regards
- IMG_5684.jpeg (487.9 KiB) Viewed 2448 times
- IMG_5685.jpeg (529.18 KiB) Viewed 2448 times
- IMG_5686.jpeg (514.52 KiB) Viewed 2448 times