New Control Board installation problem
Posted: Wed Dec 23, 2020 7:10 pm
Hi,
I have installed a new GT 2560 V3.1 on my A10M after that the orginal one is burnout.
After the installation all the stepper does not move https://19216801.onl/ https://routerlogin.uno/.
Some of you know what can I solve the problem?
Thanks
I have installed a new GT 2560 V3.1 on my A10M after that the orginal one is burnout.
After the installation all the stepper does not move https://19216801.onl/ https://routerlogin.uno/.
Some of you know what can I solve the problem?
Thanks