Cleaning the A10M hotbed

Post Reply
daves517
Posts: 1
Joined: Sat Nov 21, 2020 5:44 am

Cleaning the A10M hotbed

Post by daves517 » Fri Dec 04, 2020 7:19 pm

Hi- I am still trying to figure out the A10M. One question I have is how best to clean the hotbed. Can I use alcohol to remove some of the finer PLA that is stuck to the bed? Do I heat the bed and then try to scrape it off? I'll take any and all recommendations.
Top
Post Reply

Return to “Geeetech A10 Series”