Geeetech

Hello,

I'm new to 3d printing, but in these years I watched a lot online.
I'm printing with A10 Pro now, but I really can't seem to get it to a decent print.

I attach my print test for a cart coin.
I'm not searching for the solution ready to be used, but sincerly, I don't even know what to search for.
I need a topic, what's the problem here?
Heat? Bed? filament? Everything?!?

just to be clear:
- I used Cura with "Geeetech A10" printer already in it.
- Default configurations.
- Model taken from thingiverse
- PLA 1.75mm
- Bed 65°
- Extruder 215

(these seems to be all default values)

fun fact... the first row it prints, it's perfect.
(I mean the row it makes before starting the print, not the outside perimeter)

After that row, it comes back to "home", then point to center.
It starts moving... but nothing is going to bed now, after a few seconds of moving (10 maybe), something start to glue to bed.


I installed following the video, made test print with the dog, VERY, VERY good print!
Now it doesn't print like that at all.

Any help is appreciated.

Sorry if this is not the right place, but I don't really can't understand what problem to search.

Thanks