Incomplete/weird infill
Posted: Thu Oct 29, 2020 12:07 am
Hi,
I am trouble shooting an issue where why infill is incomplete. It seems like the nozzle isn't extruding continuously while printing infill, Dropping the infill speed in Cura down to 60mm/s, still doesn't solve the issue. This is with the grid pattern, at 20% infill.
This print was stopped halfway to see this.
If anyone has any solutions to this issue, I would greatly appreciate them.
Thanks
I am trouble shooting an issue where why infill is incomplete. It seems like the nozzle isn't extruding continuously while printing infill, Dropping the infill speed in Cura down to 60mm/s, still doesn't solve the issue. This is with the grid pattern, at 20% infill.
This print was stopped halfway to see this.
- Infill issue
- infill_issue.jpg (75.85 KiB) Viewed 2078 times
Thanks