I need some pieces of advice because i have problems with my A10.
I wanted to put a laser etcher on it and connect it to the fan plug to get my 0-5V signal.
Then i saw that the laser was always on.
I measured the output voltage of it and found something weird:
when i set the fan power to 0, i have about 22V.
when i set it to 255, i have about 9V.
My objective is to have a 0 to 5, 12, or 24V signal to run my laser.
showbox.bio/ tutuapp.uno/ https://vidmate.cool/
If anyone has ever met this problem...
(I'm french so sorry for the mistakes
)