BLTouch Autolevel issue
Posted: Tue Aug 18, 2020 9:29 pm
I have an issue with autoleveling not really working....
I have BLtouch setup and working well....I can issue an Autolevel command from the console OR the LCS dispaly and it goes through the motions of leveling in 9 points and finishes...in the center (of course I had leveled it there setting up the z offset) it prints first layer perfect, but on one edge its fat (high) and the other its squished (the extruder even ratchets due to pressure on the first layer).....autolevel offsets should have fixed this....why not?
I have BLtouch setup and working well....I can issue an Autolevel command from the console OR the LCS dispaly and it goes through the motions of leveling in 9 points and finishes...in the center (of course I had leveled it there setting up the z offset) it prints first layer perfect, but on one edge its fat (high) and the other its squished (the extruder even ratchets due to pressure on the first layer).....autolevel offsets should have fixed this....why not?