Page 1 of 1
default mix setting for A10M
Posted: Tue Aug 18, 2020 9:24 pm
by swolffke
How can we set the default mix setting for the A10M? Where in the marlin firmware or through the menu?
Kr,
S
Re: default mix setting for A10M
Posted: Wed Aug 19, 2020 3:01 pm
by William
AS shown in the picture.
Mixer menu offers two mix-printing options, namely fixed mix ratio printing mode and Mix ratio printing mode that varies with height.
Re: default mix setting for A10M
Posted: Fri Aug 21, 2020 10:31 pm
by swolffke
William wrote: ↑Wed Aug 19, 2020 3:01 pm
AS shown in the picture.
Mixer menu offers two mix-printing options, namely fixed mix ratio printing mode and Mix ratio printing mode that varies with height.
yes, i found that but it does not get saved on power off/power on...
Re: default mix setting for A10M
Posted: Mon Aug 24, 2020 9:23 am
by William
Hello, you need to save the settings in the interface shown in the figure below every time you change the printer settings.
Re: default mix setting for A10M
Posted: Fri Aug 28, 2020 4:40 am
by swolffke
Thx William for the answering so quickly
it doesn't store the mixer settings for my A10M
that is why i am trying to find out in the source where it is...
Re: default mix setting for A10M
Posted: Fri Aug 28, 2020 9:53 am
by William
Hello, you can add the following code to the star gcode of the slice software to save it.
M163 S0 P0.3
M163 S1 P0.7
M164 S4
Re: default mix setting for A10M
Posted: Sat Aug 29, 2020 7:55 pm
by swolffke
