FAQ
Posted: Wed Jul 22, 2020 6:09 pm
FAQ For Geeetech A10 series 3d pirnter
Check your PTFE tube plug is deep enough/Smooth.
Refer to this video clean your hotend.
Check the extruder motor direction is correct.
Check the spring of the feeder have enough strength/Too strength of the spring will make the filament broken.
Clean then gear of the feeder.
Check your PTFE tube plug is deep enough/Smooth.
Refer to this video clean your hotend.
Check the extruder motor direction is correct.
Check the spring of the feeder have enough strength/Too strength of the spring will make the filament broken.
Clean then gear of the feeder.