Dual part cooling fan
Posted: Sun Jun 21, 2020 4:27 am
Just hoping to tap the brains of some of you.
Since there is only one part cooling fan port on the breakout board, and I have two, I’m planning on wiring them both to one connector.
Does anyone know if there is a way to up the voltage so they’re not both running at 50%?
Since there is only one part cooling fan port on the breakout board, and I have two, I’m planning on wiring them both to one connector.
Does anyone know if there is a way to up the voltage so they’re not both running at 50%?