A10T E2 clogged E1&E3 low flow
Posted: Thu Jun 18, 2020 4:24 am
Hello,
I own my A10T now for 9 month and everything worked great.
2month ago extruder 2 doesnt get the filament pushed, 1 month ago it get clogged i can not push filament through it as hard as i try by hand.
I normaly used E2 and E3 equally only PLA and E1 was for support material PVA.
So i had one extruder less and i switched to regularly E1 PVA/PLA E3 PLA
Now i dont get a good print. The hole hotend seems to be clogged.
Ho can i disassemble the hotend and clean it?
Also my bowden tupes get stuck and i cant remove them
Hoping for fast help, vacations are incomming and there is no other hobby
kind regards
I own my A10T now for 9 month and everything worked great.
2month ago extruder 2 doesnt get the filament pushed, 1 month ago it get clogged i can not push filament through it as hard as i try by hand.
I normaly used E2 and E3 equally only PLA and E1 was for support material PVA.
So i had one extruder less and i switched to regularly E1 PVA/PLA E3 PLA
Now i dont get a good print. The hole hotend seems to be clogged.
Ho can i disassemble the hotend and clean it?
Also my bowden tupes get stuck and i cant remove them
Hoping for fast help, vacations are incomming and there is no other hobby
kind regards