Geeetech

Hi guys

I have a problem with my A10, the E driver burned out mid print resoling in the following problems after replacing the driver with a like for like part.

The control dial will now no longer scroll though the menus. I am able to press the controller in and that responds but any up or down moment is not registered.Speed Test Solitaire essay writer

I had no problems with menu moment until the driver burned out.

I've emailed Geeetech on this but need to get this thing up and running.

I've also rolled the FW back to 1.8 and cleared any setting with no change.

Anyone have any ideas?

And is there a way i can control the printer over USB?

I'm having a similar problem, which I posted in another thread on the 13th. I'm still waiting for an answer.

I can say something about the USB control question though. You can control the printer using Octoprint. This is the primary way I interacted with my A10 until I killed the motherboard.

I use a Raspberry Pi 3+, I believe. I got everything needed from Amazon. The Pi board, the power supply, and an SD card. Octoprint is free.

Hi, can you provide pictures of the motherboard after it is powered on? Or some related videos or pictures. Here you can upload compressed files