Geeetech

Hi,

The GT2560 V4 of my new A10 pro is not working (some capacitor was out of voltage and now it's not powring on)
I get a classical GT2560 but the connections of the LCD+SD is not the same.
In the two cards there is 20 pins but in the V4 all are in the same 'package' and in the card I buy there is two connections of 10 each, one for LCD and one for SD.
So I need the schema to connect LCD+SD of my A10 pro to the two connections of the 'old' GT2560

Hope my question is easy to understand, here is a photo for more details

Thank you in advance.

Hi，your question is whether this solution is feasible?

Hi William,

My question is how to do that ? it must be possible, All I need is only to know each pin on both sides: on the ( GT2650 revision A+ card) and on the LCD/SD of my A10 pro printer.

Thank you.

Sorry. This is not feasible, the pins are different, and the firmware cannot be changed.

Thank you for your response,

I already update firware of my G2560 revison A card,

Can you please help me to find pins description of the LCD of my A10 pro ? (there is 20 pins) any shema or notice ? I'll handel that

Correspond to this picture：

Thank you a lot William,

There's 20 pins in the LCD of my new 10pro, ther's only 10 on your schema.

Sorry for the mistake, this is

Thank you very match William,

So this is the pins of my LCD here (see pics)
I'll try and let you informed

Thank you again

Corresponds to this direction