Will a standard Ender 3 v1.1.4 motherboard work in an A10?
Posted: Thu Jun 04, 2020 2:13 am
This is a question that I have been mulling over since my A10 fried. I put an order in with Geeetech for a new board, but it is out of stock and they can't/won't tell me when it will be back in stock so I have no idea how long I'll have to wait.
So, in the meantime, I am wondering if I could just drop a stock Ender 3 v1.1.4 board in. I understand that the firmware might not match up just right and may need to be swapped, but is it possible?
So, in the meantime, I am wondering if I could just drop a stock Ender 3 v1.1.4 board in. I understand that the firmware might not match up just right and may need to be swapped, but is it possible?