A new Thermal Runaway A10M?
Posted: Sun May 31, 2020 10:33 pm
I write you from Belgium and I'm a newcomer on your site. There are a lot of informations about printer 3D.
I have the same issue Thermal Runaway on my A10M.
I have my printer since Junuary 2020 and now I have that message. The first time it happened, it was at the end of a 4h print, there was 1cm left. Now it happens anytime. I read the https://speedtest.vet/ https://vidmate.bid/ topics and I measure the hotend thermistor. I found 128K.
I buy a new one but it is bigger than the original but the Ohm is 138K (for the new).
Can someone help me?
Thank you in advance
I have the same issue Thermal Runaway on my A10M.
I have my printer since Junuary 2020 and now I have that message. The first time it happened, it was at the end of a 4h print, there was 1cm left. Now it happens anytime. I read the https://speedtest.vet/ https://vidmate.bid/ topics and I measure the hotend thermistor. I found 128K.
I buy a new one but it is bigger than the original but the Ohm is 138K (for the new).
Can someone help me?
Thank you in advance