Geeetech

Posted: **Tue May 26, 2020 6:33 pm**

Hi,

Just discovered that since GT2560 V4.0, no offset option are available :
- no menu item omegle discord xender : Prepare / Set Home Offsets
- no support of M428 GCode
- no support of M206 GCode

Any chance to convince development team that giving the ability to define in a permanent way offset (especially on Z) is really worth the value ?

Thanks

Posted: **Wed May 27, 2020 11:31 am**

Hi，if the auto leveling function is not used, the offset is not needed.

Posted: **Sun May 23, 2021 5:33 am**

CarsonGrey wrote: ↑
Tue May 26, 2020 6:33 pm
Hi,

Just discovered that since GT2560 V4.0, no offset option are available :
- no menu item : Prepare / Set Home Offsets
- no support of M428 GCode
- no support of M206 GCode

Any chance to convince development team that giving the ability to define in a permanent way offset (especially on Z) is really worth the value ?
TcsWebmail DadeSchools Upsers

Thanks

facing very similar issue

Geeetech

Add OFFSET ability in official Firmware (.hex) for V4 board?

Add OFFSET ability in official Firmware (.hex) for V4 board?

Re: Add OFFSET ability in official Firmware (.hex) for V4 board?

Re: Add OFFSET ability in official Firmware (.hex) for V4 board?