A10 Print Nozzle Breaks When Removing

Post Reply
dcbedros
Posts: 4
Joined: Tue Feb 18, 2020 12:37 am

A10 Print Nozzle Breaks When Removing

Post by dcbedros » Mon May 25, 2020 8:14 am

When I went to remove the nozzle on my A10 the shaft broke leaving half of the threaded portion stuck in the print head.
Just curious if there is a proper way to remove the nozzle.
I heated the print head to 200 degrees then used a socket set to unscrew it.
See attached photo - lower nozzle is the broken one.
New print head coming from Amazon tomorrow.
Thanks
IMG_20200524_200652.jpg
Lower nozzl is broken
IMG_20200524_200652.jpg (200.44 KiB) Viewed 2950 times
Top
User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: A10 Print Nozzle Breaks When Removing

Post by William » Mon May 25, 2020 10:25 am

Hi，it is recommended to replace the hot end, it is stuck inside and cannot be removed.
-Keep your mind and try to test it. :)
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Top
Post Reply

Return to “Geeetech A10 Series”