Geeetech • Outer wall /. inner wall connection

Page 1 of 1

Outer wall /. inner wall connection

Posted: Thu May 14, 2020 10:02 am

by Chub

Using Cura 4.6.1 on A10M. Why don't I get good connection between the inner and outer wall? I tried increasing over lap and no change

Re: Outer wall /. inner wall connection

Posted: Thu May 14, 2020 12:04 pm

by William

Hi,have you set the mixing ratio? Maybe one of the extruders has no material.

Re: Outer wall /. inner wall connection

Posted: Thu May 14, 2020 8:22 pm

by Chub

I am running 100% of extruder 1. No mix.

Re: Outer wall /. inner wall connection

Posted: Fri May 15, 2020 2:33 pm

by William

Hi,my friend.
I suggest you use repeater - host.
There are configuration files on the official website.
You don't have to worry about slice settings.